|
TM1200/TM1400 Trailed Mowers Welcome to the world of cutting efficiency! More cutting capacity - 15' 6" and 18' cutting widths Center-pivot maneuverability/folding. Low horsepower tractor requirements... just 85 HP minimum. Reduced costs in fuel, labor, maintenance. Ground following flotation. |
||
| Discover the efficiency and cost savings of the heavy-duty center-pivot Trailed Mowers – TM1200 and TM1400 – from Vermeer. These are the big, wide-swath machines that really make sense when the high cost of fuel, equipment and labor doesn't... allowing you to trade in all your 3-point mowers, which tie up extra tractors, extra operators and consume extra fuel. | |||
|
Flash movie can't be loaded. |
|||
){kind=link}
 | ||||
 |
|
 |
|
 |
| Overlapping independent cutterbars follow varying contours for tight cutting and cutterbar protection. | Both the TM1200 and TM1400 fold down to 8' 6" wide to quickly and easily maneuver through gates and travel from field to field. Swivel gearbox design accommodates both Cat 2 or 3N hitches. | A simple flotation gauge and knob at the front of the tongue lets you set and measure the amount of flotation. |
||
| ||||
 |
|
 |
|
 |
| A unique, patent-pending flotation/hydraulic design reduces cutterbar weight on the ground. And, because it has the ability to float up and over unforeseen field obstacles, the TM1200/TM1400 is better able to avoid or absorb high-impact shock loads. | Vermeer Quick-Clip® Blade Retention System - a Vermeer exclusive - allows you to replace or reverse blades in seconds with the Quick-Clips and a special changing tool that comes with the mower. |
Check out the rugged, reinforced frame construction. Classic Vermeer! |
||
| ||||
 |
|
 |
|
|
| The TM1200 and TM1400 feature segmented hex-shaped drive shafts and are equipped with a total of twelve self-contained cutting units mounted on the independent cutterbars. Each cutting unit is self-contained and sealed with its own set of gears, bearings and lubricant for easy maintenance and servicing; also critical if operating for extended periods of time on hills and slopes. | Hydraulic cutterbar pitch control (0 to 6°) sets the cutting height (from 1.25" to 3"), helps eliminate streaking and allows operator to adjust for different crops and conditions without tools. |
|||